1746-p4 manual

The Allen-Bradley P4 is a SLC Power Supply. This Power Supply has a nominal Input Voltage of 85 - / - VAC. It has an internal Current capacity of A at 5V dc A at 24V dc.5/5(9). Important: Use the following information, along with the installation manual for your programmable controller, to ground the chassis and your I/O modules. ground lug with mm2 (10 AWG) wire chassis mounting tab Dimensions with P4 power supply. SLC Modular Chassis Installation Instructions A4, -A7, -A10, -A13 Series B. AB Quality P4 Installation Instructions Manual (80 pages) SLC Power Supplies. Brand: AB Quality | Category: Power Supply | Size: MB. Table of Contents. 1. Table of Contents. 2.

3. For P4 power supplies, calculate total power consumption of all system devices. If not using a P4, go to step 4. CurrentMultiply By =Watts CurrentMultiply by = Watts Total Current at 5V dc A 5V W Total Current at 5V dc A 5V W. Publication INB-EN-P - March Power Supply Wiring 1. Place the input voltage jumper to match the input voltage. (This does not apply to the P3, P5, P6, and P7 power supplies, which do not have a jumper.) TIP For more information on wiring, see Allen-Bradley Programmable Controller Grounding and Wiring Guidelines. The terminals on the P4 Power Supply provide an isolated, non-fused 1A, 24V DC power supply. The P4 Power Supply has selectable V or V operation mode which can be chosen by setting a jumper, no special wiring is required. All P4 Power Supplies have an LED that indicates proper supply power and operation.

This manual is a learning and reference guide for the NI8 Analog Input Module. It contains the information you need to install, wire, and configure the module. It also provides diagnostic and troubleshooting information, and application examples. Who Should Use this Manual Purpose of this Manual. (P1, -P2, -P3, -P4, or -P5) to attach it to your chassis. Keep the connector plug on the left side-connector of the chassis if you are not connecting chassis together. Publication INB-EN-P - March 2. Connect the ground screw of the power supply to the nearest ground or ground bus. Use a mm (#14 AWG) 75° Copper wire (Category 1 per Industrial Automation Wiring and Grounding Guidelines, publication ) and keep the leads as short as possible. The P4 is shown below. 3.